Amazon Aurora Connector > Mappings and mapping tasks with Amazon Aurora > Amazon Aurora mapping task example
  

Amazon Aurora mapping task example

You can create a mapping task to read data from an Amazon Aurora source and write data to the Amazon Aurora target.
Perform the following task to create a mapping task:
    1. In Data Integration, click New > Mapping > Create .
    2. To configure the source properties and the advanced source properties, select Source from the selection panel under the Design section.
    The following image shows details of the Source Properties page:
    The following image shows the details of the Source Properties page where you can configure the source and advanced source properties.
    3. To configure the target properties and the advanced target properties, select Target from the selection panel under the Design section.
    The following image shows details of the Target Properties page:
    The following image shows the details of the Target Properties page where you can configure the target and advanced target properties.
    4. Map the source and target.
    The following image shows a sample mapped source and target.
    5. Click Save and then click Run.
    In Monitor, you can monitor the status of the logs after you run the task.