Advanced FTPS V2 Connector > Mass Ingestion Task with Advanced FTPS V2 Connector > Mass ingestion task example
  

Mass ingestion task example

You can create a mass ingestion task to move files from an Advanced FTPS V2 source to an Amazon Redshift V2 target.
Perform the following steps to create a mass ingestion task:
    1. In Data Integration, click New > Task.
    2. Select Mass Ingestion and then click Create.
    The Definition tab appears.
    3. In the Definition tab, configure the basic task properties.
    4. Click Next.
    The Source tab appears.
    5. On the Source page, , in Connection Type, select Advanced FTPS V2 and then configure the Advanced FTPS V2 source properties.
    6. Click Next.
    The Target tab appears.
    7. On the Target page, in Connection Type, select Amazon Redshift V2 and then configure the Amazon Redshift V2 target properties.
    8. To view the connection details, click View.
    9. To test the connection, in the View Connection dialog box, click Test.
    10. Click Next.
    The Schedule tab appears, where you can select whether to run the task on a schedule or without a schedule.
    11. To run a task on a schedule, click Run this task on schedule and select the schedule you want to use.
    If you want to remove the schedule, click Do not run this task on a schedule.
    12. Click Finish to save your settings and close the task wizard.
You can edit, run, or view the mass ingestion task on the Explore page after you create the task.